Do you know how many basic application and adjust methods of pneumatic cable stripping machine?
Adjust methods of pneumatic cable stripping machine
1, connect air inlet pipe with air supply 4.5-7kg/sq.cm.
2, plug power cord into 220V 50Hz power supply.
3, foot switch to make the cylinder action.
4,... read more
3FN pneumatic wire stripper twister is professional designed and manufactured wire processing equipment for all kinds of electronic wire and double wire with wire twisting stripping function.
This utility model has the advantages of low labor cost, high working efficiency, and small and practical effect.
3FN... read more
1) intake manifold access gas source 4.5-7kg/cm2
2) Power cord plug into a 220V 50Hz supply
3) step on pedal to run cylinder
4) double-knives model basic usage is ibid consistent, design for primary wire cutting and stripping. Should pay attention to the following points:
a) without adding... read more
Operation method of 3F pneumatic cable stripping machine:
1, the air inlet pipe connecting the air supply 4.5-7kg/ 2 cm
2, the power cord plug into the 220V 50Hz power supply
3, the foot switch to make the cylinder action
4, as shown in Figure two, trimming operation key:... read more
Due to the advent of 5g era, coaxial cable stripping has also become a popular wire harness processing machine recently. Since coaxial cable is generally used in high frequency communication, and general wire cutting stripping machine can only strip single layer insulation, therefore this... read more