Let’s analyze how to solve the following two kinds of faults in using fully automatic wire tin dip soldering machine:
The fully automatic wire tin dip soldering machine is weak. When feeding, user feels that the wire cutting machine is unable to operate and the cut wires are not in order. At this time, we need to increase the power, adjust the motor or tighten the screws.
When the automatic tin machine is working, it suddenly makes disorderly noise. At this time, it is necessary to stop the operation in hand for relevant inspection. Noise indicates that the machine is blocked or the machine components are faulty, or the voltage may be unstable.
When using the fully automatic wire tin dip soldering machine, it should be cleaned one day, and maintained one week. The maintenance is mainly to reduce the friction of the lubricating oil on the slide rail, chute and moving bearing, so as to prolong the service life, if wire end cannot be dipped soldering, please check whether the wire end intrudes into the tin. If it is immersed into the tin, then check whether the wire end is immersed into the flux, and if the wire end is not immersed into the flux, it is also not dipped soldering.
For the first time, the technicians who use the fully automatic wire tin dip soldering machine must read the instructions or be trained. Many people use the fully automatic wire tin dip soldering machine for the first time without the training of relevant technical personnel. The machine equipment is different from other things. A little carelessness will cause machine damage and even safety accidents.

Share this post