fully automatic wire terminating machine operating procedures

Shenzhen Fortune Sky Technology Co.,Ltd tell you the fully automatic wire terminating machine operating procedures 3.1 Checking fully automatic wire terminating machine before its start : 3.1.1 check whether the switch is good. 3.1.2 check the electrical device is normal (Power: 220V, air pressure: 3.5-6.5 pure) 3.1.3 Lubricate in the sliding part, clean the machine and keep maintenance records 3.2 fully automatic terminal crimping machine operation steps: 3.2.1 place semi-finished products that inserted into the terminal on the table to be pressed. 3.2.2 will be stamping semi-finished plastic down, metal [...]

cable lug terminal crimping machine

What are the common fatal faults of the lug/terminal/ferrule?

What are the common fatal faults of the lug/terminal/ferrule? 1, poor insulation The function of the insulator is to keep the contact part in the correct position, and make the contact between the contact part and the complex part. Therefore, the insulation must have excellent electrical properties, mechanical properties and mechanical properties of the conveyor molding. Especially with the high density, the miniaturization of the wide use of terminals, the effective wall thickness of the insulator thinner and thinner. It puts [...]

Fully Automatic Gold Plated Contact Wire Lug Crimping Machine

Full Digital Intelligent Terminal Crimping Machine Failure Elimination

Full Digital Intelligent Terminal Crimping Machine Failure Elimination Failure 1: Stripping front opening length varies. Reason a: Feeding wire wheel is too tight or relaxed; Solution: use wheel trimming bar to adjust two wheels gap so as not to press the wire firmly or too relaxed to slip the wire. Reason b: cutting and stripping knife cut too shallow or too deep; Solution: use knife deep shallow adjust bar to move knife-edge to the appropriate location, in order not to hurt the copper wire [...]

Full Automatic Terminal Crimping Machine Operation Procedure

Full Automatic Terminal Crimping Machine Operation Procedure 3.1 Automatic Terminal machine examation before switch on: 3.1.1 check each switch is unwounded. 3.1.2 Check the electrical installations are normal (power supply: 220V, Pressure :3.5-6.5 Pure) 3.1.3 Inject lubricating oil to sliding parts, clean the machine and make the maintenance records. 3.2 full automatic terminal crimping machine operation steps: 3.2.1 Place the plugged terminals on the bench ready for crimping. 3.2.2 Put Semi-finished plastic down, metal terminal strip up, placed terminals to feeding board. 3.2.3 Switch on, machine crimp [...]