27 Apr

Most complete automatic belt loop cutter common failure problems and several corresponding solutions

1. No power supply? 1. Check whether the power connection plug is in good contact? Check whether the fuse is broken? 2. There is power supply, but it cannot be started, the sensor is wrong, the cutter seat sliding sleeve is stuck or there is no air pressure? 1. Check if the cylinder is ventilated, if not, open the valve. Check whether the cutter seat sliding sleeve is stuck, and fill the sliding sleeve with lubricating oil. 3. No material alarm? 1. Whether the [...]

By Hot Cold Strip Cutting Machine , , , , , , , , , , , Read more...
26 Apr

What are the installation and debugging steps of the computer tape cutting machine after it is delivered to the factory

We tell you what are the installation and debugging steps of the computer tape cutting machine after it is delivered to the factory. Customers need to install and debug after receiving the computer tape cutting machine before it can be applied. What are the installation and debugging steps of the computer tape cutting machine? 1. Make preparations first, prepare the site, power supply, etc.; 2. Inventory of the received EPE vertical cutting machine accessories; 3. Frame rail; 4. The four feet of the guide [...]

By Hot Cold Strip Cutting Machine , , , , , , , , Read more...
26 Apr

Common faults and solutions of belt loop cutter

Next, we will continue to share with you the troubleshooting methods that often occur in the daily practical use of automatic belt loop cutter, and how to deal with a series of fault problems. 1. When using hot cutting, the tape cannot be cut (1) Check whether the temperature reaches the preset temperature. (2) Check whether the hot knife is heated. 2. No power supply (1) Check whether the power connection plug is in good contact. (2) Check whether the fuse is disconnected. 3. There is [...]

By Hot Cold Strip Cutting Machine , , , , , , , , Read more...
26 Apr

Common faults and solutions of belt loop cutter

Next, we will continue to share with you the troubleshooting methods that often occur in the daily practical use of automatic belt loop cutter, and how to deal with a series of fault problems. 1. When using hot cutting, the tape cannot be cut (1) Check whether the temperature reaches the preset temperature. (2) Check whether the hot knife is heated. 2. No power supply (1) Check whether the power connection plug is in good contact. (2) Check whether the fuse is disconnected. 3. There is [...]

By Hot Cold Strip Cutting Machine , , , , , , Read more...
25 Apr

Solution of no display of automatic strip cutter

We tell you the solution for no display on the control panel: If the machine is used continuously for a long time, the temperature inside the case may be extremely high, and the display may be abnormal. This is a normal phenomenon. Stop working, turn off the power switch, and turn it on after a while. The display should be normal. If it is in cold state If the boot display is abnormal, please turn off the power and wait [...]

By Hot Cold Strip Cutting Machine , , , , , , Read more...
Online Service
Live Chat