3F pneumatic wire stripping machine for core wire insulation stripping.

basic operation method of 3F pneumatic cable stripping machine

Do you know the basic operation method of 3F pneumatic cable stripping machine? Operation method of 3F pneumatic cable stripping machine: 1, the air inlet pipe connecting the air supply 4.5-7kg/ 2 cm 2, the power cord plug into the 220V 50Hz power supply  ‘ 3, the foot switch to make the cylinder action 4, as shown in Figure two, trimming operation key: loosen the nut in middle of headless screw,nut 1 control upper clamp block up and bottom; nut 2 control knife mold [...]

This machine uses a hybrid drive microcomputer control system of the whole LCD screen, cutting,stripping,twisting,middle stripping, one-time completion, but also the front half stripping with twisted wire function, protect the integrity of the wire, special wire can instantly change the size of wire specification.

Do you know how many solutions for faults of wire stripping machine?

Do you know how many solutions for faults of wire stripping machine? Do you know how many solutions for faults of wire stripping machine? 1.) run silent appear “Err02”: fuse is broken, replace it and try again, if broken again, need to replace one of the drive board. 2.) run but immediately shut down to display “Err02”: wire section is too thick, too fast, slow adjustment again; insufficient voltage stabilized power supply, with independent; cutter head sensor dust or knife head sensor [...]