12
Mar
The computer automatic cold and hot strip cutting machine has the following characteristics:
1. The machine tool is made of imported high-quality steel after special treatment. The cut surface is flat during hot cutting, and the hot knife can heat seal the cut surface of... read more
10
Mar
Next, we will share with you the maintenance methods that often occur in the daily practical use of this automated velcro tape cutter.
1. The cutter keeps cutting, how to deal with no feeding?
(1) Whether the materials are used up, please replace with new materials.
(2)... read more
12
Mar
We tell you the solution for no display on the control panel:
If the machine is used continuously for a long time, the temperature inside the case may be extremely high, and the display may be abnormal. This is a normal phenomenon. Stop working, turn... read more
10
Mar
1.The bearing of knife is broken in the automatic strip cutter. Check the reason, replace the bearing.
2. Wear of the middle knife. The middle knife has cutting edges on both sides, one side can be worn and the other side can be used or... read more
17
Mar
What is the problem with the automated strip cutting machine faulty knife that cutting cannot stop? How to solve it
1. Check whether the circuit connecting the motor is short-circuited.
2. There is a problem after startup. Check whether the sensor at the connecting rod is... read more
17
Mar
We tell you what are the installation and debugging steps of the hot cold strip cutting machine after it is delivered to the factory.
Customers need to install and debug after receiving the hot cold strip cutting machine before it can be applied. What are... read more
30
Apr
Product features of automatic tubing cutter for pvc flexible conduit:
(1) High-speed automatic feeding, controlled by a microcomputer program with an accuracy of 0.1mm; 30,000 short materials can be cut per hour
(2) In automatic or manual operation, it can feed forward or backward, and it... read more
29
Apr
The computerized belt loop cutter is composed of a cutter and a knife frame. The knife frame is installed on a base. Its innovation is: a symmetrical vertical mounting plate is fixed on the base, and the mounting plate is vertically guided between the... read more
26
Apr
Next, we will continue to share with you the troubleshooting methods that often occur in the daily practical use of automatic belt loop cutter, and how to deal with a series of fault problems.
1. When using hot cutting, the tape cannot be cut
(1) Check... read more
11
Mar
Fully automatic cutting, simple operation, wide application range, high cutting quality, cold and hot knife can cut.
High speed: 80 to 100 pieces can be cut per minute. (Take 50mm length as an example)
High precision: each cut is monitored by a stepping motor to ensure... read more