Before using the automatic wire terminator, it is beneficial to know more about its common faults. When there is a fault, we can quickly know the cause of the fault and take effective measures to solve it in the first time. Today, we will talk about the three most common troubleshooting solutions of the automatic wire terminator in detail. When there is a fault problem, it will be more convenient to solve it. When the automatic wire terminator breaks down, don’t panic. First [...]
Analysis of the problems caused by the wiring of the fully automatic wire crimping machine and the effects
Even the fully automatic operated fully automatic wire crimping machine can also cause malfunctions and adverse effects, so we often find some bad phenomena in actual operation. There are main reasons as follow: One is the unsatisfactory contact of wire terminals. In the final analysis, this is due to the unreasonable design of the corresponding infrastructure or the inconsistent selection of materials, which makes the normal transmission of voltage, current, signal and so on impossible. The other is the problem of poor fixing. The insulator on the terminal is not only to play an insulating role, but also to provide corresponding protection, positioning, fixing and other functions. The reason for poor fixation is actually from design, material selection, process and other factors. In addition, poor insulation is also one of the common problems of terminals. Because there are some impurities such as metal redundancy, dust and flux on the surface and inside of the insulator of fully automatic wire crimping machine, ionic conductivity will be formed in the case of dampness and mildew, which leads to poor insulation phenomena such as short circuit, low insulation resistance, leakage and breakdown. What functions does the wire crimping machine can provide? The fully automatic ribbon cable wire crimping machine is used to connect terminals. It is used to facilitate the connection of wires. It is actually a piece of metal sealed in insulating plastic. Both ends have holes to penetrate the wires. There are screws to fasten or loosen the wires, for example, two wires, sometimes need to be connected, sometimes need to be disconnected. At this time, they can be connected by terminals. And can disconnect at any time, without welding them together or surround them, very convenient and fast. And suitable for a lot of wire interconnection, in the power profession there are special terminal row, terminal box, which is full of terminal, single-layer, double-layer, current, voltage, general, breakable and so on. Our wire crimping machine has a certain crimping area in order to ensure reliable touch, as well as to ensure that the current can be satisfied. The fully automatic ribbon cable wire crimping machine uses the existing track connection terminal connection skills, and installs a circuit composed of electronic components to complete the transmission coupling of photoelectric process.