Fully automatic wire cutting and stripping machines: How to set up and adjust wire stripping

The setup and adjustment of fully automatic wire cutting and stripping machines mainly involve the following steps:

Adjustment of the stripping blade position:

Firstly, confirm the position of the stripping blade, which can be done by using light illumination or manual touch.
Move the stripping blade to the correct position, ensuring it contacts the outer insulation of the wire but does not cut through it.
Test the stripping effect to ensure that the insulation is completely removed without damaging the wire core.
Adjustment of the cutting depth:

Confirm the diameter of the wire core to ensure the cutting depth is suitable.
Adjust the cutting depth of the stripping blade to remove all insulation without harming the wire core.
Test the stripping effect again to confirm that the insulation is not cut through and the wire core remains intact.
Adjustment of the stripping force:

Determine the appropriate stripping force based on the diameter of the wire to be stripped.
Adjust the stripping force considering the hardness of the insulation and the diameter and material of the wire.
Finally, test the stripping effect to ensure that the stripping force results in an appropriate stripping width without damaging the wire core.
Adjustment of the stripping speed:

Determine the appropriate stripping speed based on the type and material of the wire.
Set the appropriate stripping speed, usually achieved by adjusting the motor’s rotation speed.
Finally, test the stripping effect to confirm that the stripping speed is moderate and does not result in damage to the wire core or leave behind parts of insulation that cannot be stripped.