Setting up and adjusting a fully automatic wire cutting and stripping machine typically involves the following steps:
Preparation Stage: Start by placing the cable to be stripped into the stripping clamp of the fully automatic wire cutting and stripping machine. Adjust the position and clamping force of the stripping clamp to ensure the cable is securely held during the stripping process.
Parameter Settings: Choose an appropriate stripping blade head based on the diameter range of the wire. Adjust the depth of the stripping and ensure it is suitable. Then, based on the material of the cable and the desired stripping effect, adjust the stripping speed and force to achieve the ideal stripping result.
Operating Stage: Turn on the power switch of the wire cutting and stripping machine, and initiate the machine. Insert the cable into the stripping clamp, and once the machine starts working, the cable will be automatically stripped. Observe if the stripping result meets the requirements and make corresponding adjustments to achieve better results.
Stripping Length Setting: Use the buttons on the automatic wire cutting machine’s panel or software to set the stripping length.
Stripping Depth, Speed, and Force Settings: Use the buttons on the automatic wire cutting machine’s panel or software to set the stripping depth, speed, and force.
Stripping Frequency Setting: Set the desired stripping frequency, usually adjustable through the panel buttons or software.
Blade Alignment Adjustment: Use adjustment tools to align the blades, fine-tuning the height and lateral position as needed for the best stripping result.
Tool Position Adjustment: Insert the wire to be stripped into the stripping port for testing. Observe the stripping result, and if the stripping is incomplete or too deep, adjust the tool position.
Machine Circuit Adjustment: Check the machine circuit connections, ensuring that power and signal lines are properly connected. Open the computer control, enter the debugging interface, and inspect circuit boards such as the axis control board, input/output board, and needle board to ensure proper connections.
Machine Blade Alignment Adjustment: Use adjustment tools to align the blades, fine-tuning the height and lateral position as needed for the best stripping result.
These steps cover the setup and adjustment of a fully automatic wire cutting and stripping machine, ensuring an efficient and consistently high-quality stripping process.
