Do you know how many basic application and adjust methods of pneumatic cable stripping machine?

Do you know how many basic application and adjust methods of pneumatic cable stripping machine? Adjust methods of pneumatic cable stripping machine 1, connect air inlet pipe with air supply 4.5-7kg/sq.cm. 2, plug power cord  into 220V 50Hz power supply. 3, foot switch to make the cylinder action. 4, the use of double-cutters model is basically same as above, design for the wire cutting and stripping in one time. Need to pay attention to the following points: A) without gasket, the gap between cutter and stripping [...]

LL-3FN Pneumatic Wire Twisting Stripping Machine For Multicore Cable

Structure And Feature For Pneumatic Wire Twisting Stripping Machine For Multicore Cable

Structure And Feature For Pneumatic Wire Twisting Stripping Machine For Multicore Cable LL-3FN pneumatic wire twisting stripping machine for multicore cable included rack, up and down templates, each equipped with a stripping knife on both templates and clamp block; up and down knife holders connection through the guide column, templates on the rack fitted with two cylinders, respectively control stripping knife and clamp block, there is a controlled stripping cylinder after the rack,there is a small tooth block that twisting apparatus [...]

Basic application for pneumatic cable stripping machine

Basic application for pneumatic cable stripping machine Regulation of pneumatic cable stripping machine: 1) intake manifold access gas source 4.5-7kg/cm2 2) Power cord plug into a 220V 50Hz supply 3) step on pedal to run cylinder 4) double-knives model basic usage is ibid consistent, design for primary wire cutting and stripping. Should pay attention to the following points: a) without adding gasket, the gap between cutter and stripper is 1.5mm b) add or less gasket should be careful of uniform thickness of up and down to avoid die  [...]