What to Do When the Computerized Fully Automatic Wire Cutter & Stripper Machine Can’t Strip the Wire Ends

When the Computerized Fully Automatic Wire Cutter & Stripper Machine fails to strip the wire ends, the following measures can be taken to solve the problem:

Check the cutting blades of the stripping machine. If the blades are worn or damaged, it may cause the wire ends to be clamped or cut, so it is necessary to check the condition of the blades and replace them if worn.

Adjust the pressure of the stripping machine. The pressure of the stripping machine directly affects the stripping effect. If the pressure is too high, the wire ends are prone to be clamped; if the pressure is too low, the wire ends are prone to be cut off.

Replace the appropriate stripping heads. Choose the appropriate stripping heads according to the diameter and material of the wire. Using inappropriate stripping heads can also cause the wire ends to not strip properly.

Adjust the depth of the cutting blades of the stripping machine. The blade depth refers to the depth at which the blade contacts the wire. If the depth is too shallow, the blade cannot cut through the insulation layer; if it is too deep, the wire may be cut off.

Check the quality of the wire. If the wire quality is poor, the insulation layer may be very hard to strip, so it is recommended to use higher quality wire.

Check if the wire is correctly installed. Ensure that the wire is properly installed in the clamping device of the stripping machine to prevent the machine from failing to strip properly.

Adjust the cutting head of the automatic wire stripping machine. Adjust the position of the stripping blade according to the diameter of the wire to ensure that the blade completely strips the insulation layer. Also, check the sharpness of the blade. If it is dull, it needs to be replaced.

Check the track and conveyor belt of the automatic wire stripping machine. Ensure that there are no foreign objects jammed or misaligned, causing the machine to malfunction.

Check the depth of wire cutting. If the cuts are too shallow, adjust the size of the cutting parameter.

Adjust the clearance between the wire feeding drive wheels. If the clearance is too large, adjust it accordingly.

Clean the wire feeding wheel and the blade retraction wheel. If there are any contaminants on the wire feeding wheel or the blade retraction wheel, clean them thoroughly.

Check if the air source is normal. Ensure that the air source is normal to avoid affecting the stripping effect.

If none of the above methods can solve the problem, it is recommended to contact the manufacturer of the automatic wire stripping machine or professional technicians for inspection and maintenance.