User Guide for Multi-Core Cable Stripping and Crimping Machine

I. Methods to Avoid When Using the Terminal Machine

Check if the power cord is plugged into the power socket and if the power plug is inserted into the terminal machine power socket.
Inspect whether the wiring board is securely connected and if the connections are correct.
Ensure that the protective door of the terminal machine is properly closed.
Check if the circuit between the plug and socket is clear.
If none of the above methods can solve the issue, it is necessary to seek assistance from professional technicians.
II. Solutions for Loose Terminals

Causes of loose terminal buttons: flipping or loosening, screws being too loose or too tight, etc.
Solution: Reconfirm whether the buttons of the machine are tightly fastened, if the brass compression screws are symmetrically tightened, if the thickness of the brass U-shaped pieces is consistent, and if the screw is adjusted to the optimal pressure adjustment position.
Reasons for insufficient sharpness of terminal teeth: wear of teeth or incorrect cutter angles.
Solution: Replace with sharper teeth or peeling heads to increase friction between them and the terminal copper sheet, thus enhancing the tightness.
III. Methods for When Terminals Cannot Be Produced Continuously

Check if the fixing screws and eccentric are strong and movable.
Verify if the lengths of terminal copper pieces are equal, if there are impurities in the copper wires, and try restarting the terminal machine.
Inspect if the terminal teeth are fatigued and need replacement.
IV. Solutions for Irregular Terminals

Ensure that the copper wire is cut flat, the peeled copper strip is flat, and the finished product is properly fixed, leaving about 1mm from the finished product. The terminal outlet should not be too long, otherwise, it will reduce the tightness of the terminal.
Remove a section of the peeling operation to reduce the wall thickness and promote terminal crimping.
V. Recommendations for Terminal Machine Operation Skills

Before use, confirm the power and air pressure.
Avoid wearing gloves during use, and always operate the machine on the corresponding workbench.
Clean up waste products and debris promptly.
For terminals BHT1.25-BHT14, use the 23DW matching model; other models need to be matched according to different terminal specifications.

[Conclusion]
This article provides detailed answers to common problems encountered when using the Multi-Core Cable Stripping and Crimping Machine, including issues with machine usability, loose terminals, inability to produce continuous terminals, and irregular terminals. It also offers corresponding solutions and operating techniques. During the use of the terminal machine, it is important to adhere to relevant safety procedures to prevent accidents.